NeckLume Pro: 7-in-1 LED Heat & Vibration Face & Neck Massager

Quick-Start Guide
1. Prep: Cleanse face and neck. Apply your favourite facial oil, serum, or moisturiser evenly. (Never use on dry skin to prevent tugging).
2. Power On: Hold the power button for 2 seconds. Tap to select your preferred LED light and massage mode.
3. Glide: Place the 160° dolphin-tail head flat against your skin. Sweep upward from collarbone to jawline, and outward from centre-face to ears.
4. Clean: Press and hold power for 2 seconds to turn off. Wipe the metallic head with a dry microfibre cloth and replace the cap.

3-Step Daily Sculpting Routine (5–10 Mins Total)
Perform these modes consecutively once daily for maximum anti-aging and firming benefits:

Step 1 – Deep Cleanse (Clean Mode): Cycle to your preferred LED colour (Green or Blue work well here) and select Clean Mode to clear trapped oil and minimise pores. Sweep upward along the neck and cheeks for 2 minutes to refresh the skin surface.

Step 2 – Serum Lead-In (Relax Mode): Cycle to Purple, Cyan, or Yellow light and select Relax Mode to boost skincare absorption and support lymphatic drainage. Glide outward from the nose toward the ears, then down the sides of the neck to drain puffiness.

Step 3 – Thermal Lift & Contour (Hot Mode, 45°C): Cycle to Red or White light and select Hot Mode to stimulate collagen production and tighten the double chin area. Apply gentle upward sweeps on the jawline and neck to firm sagging skin.

Pro Tips for Best Results

Move Upward & Outward: Always work against gravity on the neck, and centre-to-outward on the face.

Flush Contact: Keep the entire 160° curved head flat against skin to get full thermal heat and LED light coverage.

Consistency Wins: Daily 5-minute sessions deliver significantly better results than sporadic long sessions.

Charging & Safety: Charge fully (2 hours) before use. The device auto-shuts off after 1 minute of inactivity and will not operate while plugged into the charger.